A corrosion-resistant etch primer that is designed to be used under one-pack or two-pack products.
Surface preparation Blast clean and remove wax, oil and grease with a solvent cleaner. Carry out wet abrasion with Solvalux 5-30 and an abrasion paper, to remove all contaminants and improve adhesion. Make sure the surface to be coated is clean and dry. Non-ferrous metals such as GI, aluminium and copper make sure that only zinc is abraded away and remove wax etc. with a solvent cleaner.
Application procedure Apply Epilux 70 with an airless spray, after mixing the base and acid diluent in the ratio 4:1. Overcoat it with recommended coating as per system chosen. Use an airless spray or conventional. For difficult shapes and touching up, use a brush or roller.
Tools you will need
17.0 m2/Ltr @ 50 Micron DFT**
On well-prepared surfaces, as per the painting system recommended. Please refer to the Product Data Sheet for surface preparation and method of application.
** Actual coverage may vary from the quoted coverage due to factors such as method and condition of application, surface roughness, and porosity.
8.5% +/- 0.5%
Pre-treatment of non ferrous metal
Make Your Plan
Let us design a project plan to suit your needs.